Category: Lpmp stream condensate recovery system
Tel: +86-13736311582
Fax: +86-577-67358700
E-mail: sale@greatdesignvalve.com
PRODUCT DETAILS
Condensate Recovery System With Four-pumps in Parallel
Model: HPT10,HP10,HPT30,Hp30
Automatic Steam (or gas) powered Condensate Pumps
This range of self-contained pumps uses steam or other pressurised gas as motive power and is designed to remove and recover condensate (or other fluids) under all operating conditions. They are ideal for use in hazardous areas where electrical pumps would not be suitable, and for the efficient drainage of heat exchangers.
Features:
1、Discharging and recovering condensate can improve production efficiency , save energy, reduce water treatment cost, and fully utilize steam.
2、Eliminates water hammer, avoids equipment damage, and improves the reliability and safely.
3、Effectively recovers condensate , reduce the cost of boiler fuel and water treatment for reuse , and that of down steam water treatment and drainage.
4、Recovers condensate with temperature of up to 185℃ with out evaporation.
When Selecting a suitable model:
1、Make sure of the max. Flow rate of the pump medium.
2、Make sure of the characteriatic , pressure and temperature of the motive medium.
3、Make sure of the total back pressure of the pump.
(1) Vertical lifting height.
(2) Pressure of condensate recovery line(MPa)
(3) resistance loss of pipelines, valves and fittings.
4、Motive medium pressure provided by customer must be 0.1-0.15 MPa higher than the total back pressure.
MAIN PARTS MATERIALS
| No. | Name | Qty. | Material | Rmarks |
| 1 | Set water tank | 1 |
|
assemble |
| 2 | Inlet assemble | 1 |
|
assemble |
| 3 | Pump Body | 1 | WCB |
|
| 4 | Trim | 1 | SS |
|
| 5 | Outlet assemble | 1 |
|
assemble |
| 6 | Driving air pipe | 1 |
|
assemble |
| 7 | Air vent pipe | 1 |
|
assemble |
| 8 | Gasket | 1 | graphite+SS |
|
| 9 | Drain plug | 1 | 45# |
|
| 10 | studs | 1 | 8.8 |
|
MAIN DIMENSION(mm)
| Type | L | W | H |
| Single Pump System Assemble | 1150 | 750 | 1670 |
|
Double Pump System Assemble |
1170 | 1150 | 1760 |
| Size | A | B | C | D |
| Pump Body | 340 | 540 | 540 | 130 |
STANDARD
1.Design & Manufacture:JB/T11170-2011
2.Discharge 25kg condensate at each working time.
3.The thickness of the weld seam more than 6 mm for Each welding position
MAIN PERFORMANCE SPECIFICATION
SELECT DATASHEET
EN